7PCS Sensor Socket Set
- 【High Qulity】Made of high performance chrome molybdenum and solid cast steel construction for strength and durability – Finished with Black Oxide to prevent rust and corrosion.
- 【Design】Standard 6 point with low profile and 8mm x 64mm side cutout design to enable you remove oxygen sensors with the wiring harness still attached, and the socket is offset and compact which allows extra leverage even in hard to reach spots.
- 【USE】 Built for use with 3/8” ratchets, 1” wrenches, and breakers bars to remove and install oxygen sensors and hex vacuum switches on vehicle, even if you don’t have a lot of experience working with cars. This high quality tool can save your time!
Most Modern Vehicles
1PC 1/2” Drive x 27mm (12 point) oil pressure sending unit socket.
1PC 1/2” Drive x 29mm (6 point) pressure/vacuum switch socket with slot. Oil pressure sending units on late 1980 and mid 1990 GM vehicles. Designed to be used with 1/2″ drive tool.
1PC 1/2” Drive x 7/8”or 22mm (6 point) long sensor wrench socket with slot.
1PC 3/8” Drive x 7/8” or 22mm (6 point) vacuum switch socket with slot.
1PC 3/8” Drive x7/8” or 22mm (6 point) vacuum switch socket with slot.
1PC 3/8” Drive x 1-1/16” ; 1”or 27mm (6 point) oil pressure sending unit socket. Special deep design fits oil switches up to 2-5/8″. Can be used with a 3/8″ drive ratchet or 1-1/8″ wrench.
1PC 3/8” DR x 7/8”or 22mm (6 point) short sensor wrench socket with slot.
Ideal for, inspecting, replacing and installing heated and unheated sensors on most vehicles
Construction of chrome vanadium steel for extra strength and durability
Cut-out and slotted design enables sockets to be fitted over wiring harness, offset and compact allows for extra leverage in hard to reach spots
|Dimensions||23 × 36 × 25 cm|
Chrome Molybdenum Steel